Title: Arp hold led stays on while the hold mode is already deactivated
Category: UI
Steps to reproduce:
- Enable the Arp by pressing the "Arp On" button
- Go to the Arp menu
- Turn the Hold Mode off by turning the encoder that is assigned to this parameter in the center section
- If you stop turning the encoder right after the hold mode is switched off the center screen indicates that the hold mode is off while the hold led is still lit.
Arp hold led on while hold mode is already deactivated
Moderator: Solaris Moderators
-
- Site Admin
- Posts: 2002
- Joined: Sat Apr 07, 2007 3:00 am
- Contact:
Re: Arp hold led on while hold mode is already deactivated
The alpha dial is not being used to change the Hold parameter. Encoder below it or keypad (0/1 enter) works, but not with the alpha dial. Easy fix.
Re: Arp hold led on while hold mode is already deactivated
But the described behavior happens when you use the encoder.
-
- Site Admin
- Posts: 2002
- Joined: Sat Apr 07, 2007 3:00 am
- Contact:
Re: Arp hold led on while hold mode is already deactivated
Ah, I see...it's one turn less...just need to do the displayed parameter and the LED at the same time! Thanks!
Who is online
Users browsing this forum: No registered users and 81 guests