About the Hold function

Moderator: Solaris Moderators

koenig
Posts: 65
Joined: Mon Nov 04, 2013 2:03 am
Location: Sweden
Contact:

About the Hold function

Post by koenig »

I was playing with an apreggiator preset, 2.13 "CL Stash ARP", when I noticed that the Hold function in the Arp screen behaves a bit odd:

Switch to the Arp screen and turn the Hold encoder slowly and you will notice that Hold button LED lights up but the status on the graphical screen is still "off". If I turn the encoder yet another twist then the status message changes to "on" and the Hold function kicks in - just as if I hit the Hold button.

The same applies in the reverse, i.e., if I twist the knob slowly I will see that the status message goes to "off" (as does the Hold function) but the light above the Hold button is still lit.

Just a cosmetic issue but worth mentioning I suppose.
koenig
Posts: 65
Joined: Mon Nov 04, 2013 2:03 am
Location: Sweden
Contact:

Re: About the Hold function

Post by koenig »

Similar to this one, previously reported, on the Arp button: viewtopic.php?f=19&t=16167
Post Reply

Who is online

Users browsing this forum: No registered users and 13 guests