Page 1 of 1

Vibrato LFO improvements

Posted: Mon May 04, 2015 12:38 pm
by christeck
Thanks for the plethora of LFOs on the Solaris.

The fifth is a dedicated vibrato LFO. Great.

With the modulation wheel set to enabled, it only takes effect as soon the modulation wheel is moved. Great.

In case one wants to use the LFO for some light vibrato, increased by the modulation wheel, things become less straigtforward. One sets the modulation wheel to »Off«. Then the modulation wheel can be used as a modifier to control the level. Great.

Then the level gets set to a value greater then »0« to apply some basic vibrato to the sound. However, the minimum level of »1« already results in a rather harsh vibrato. Pressing shift does not result in a finer resolution. Which is what I'm requesting :) .

ATM I do this by using one of the other LFOs and applying it to each individual oscillator. Which is an easy workaround. But I thought the vibrato LFO was thought as a shortcut to make this set up even easier :) .

Re: Vibrato LFO improvements

Posted: Wed May 13, 2015 1:15 am
by John Bowen
Hmmm, I will check this. So, the minimum amount you can set is too much vibrato....I would try entering a lower value (like .5?) from the keypad to see if that way works.

Thanks for the note!

Re: Vibrato LFO improvements

Posted: Sun May 17, 2015 1:31 pm
by christeck
Ah, keypad. Thanks for the worthy hint.

The level parameter accepts integer values only, though. Thus I keep my request in place.

It's a minor issue, though, since I can use another LFO and apply it to each individual oscillator as a workaround.

Re: Vibrato LFO improvements

Posted: Sun May 17, 2015 9:43 pm
by John Bowen
So, I also checked here - and what you are talking about is the Level parameter for the Vibrato LFO, I think. At the first increment it’s 1%, and that is too much.

It should be something fairly easy to change - I willl have to add it to the list of things!

Thanks,
john b.