Preset data locations
Posted: Thu May 04, 2017 10:30 pm
Hi all,
I must say I am enjoying a much better functioning Solaris due to the firmware updates.
I was trying out the Solaris Patch name editor and could not find a few banks I had created. So I looked at the files on the chip to find there was no Bank 20 and 30. I used bank 20 just as a place for a recent show and today I started doing some new patches which I were putting in bank 30. Neither of these show up on the chip but they are definitely there when I load them in on the Solaris ?
Note that there isn't any banks from 14 to 20 or 21 to 29. I know that if I happen to look at these missing banks then I get the data from the preceding bank number that does have patches.
Using firmware solarisos_v1.3.0.5
Any ideas ?
I must say I am enjoying a much better functioning Solaris due to the firmware updates.
I was trying out the Solaris Patch name editor and could not find a few banks I had created. So I looked at the files on the chip to find there was no Bank 20 and 30. I used bank 20 just as a place for a recent show and today I started doing some new patches which I were putting in bank 30. Neither of these show up on the chip but they are definitely there when I load them in on the Solaris ?
Note that there isn't any banks from 14 to 20 or 21 to 29. I know that if I happen to look at these missing banks then I get the data from the preceding bank number that does have patches.
Using firmware solarisos_v1.3.0.5
Any ideas ?