John Bowen Synth Design

There Ya' Go................... From a beautiful programmer............ Just realized on Bank 7 Preset 29 MWh Rotor 1, that the volume out in Mixer 4 must be reset and stored at 106 for the Rotors to be blended via Mod Wheel.....Sorry 'Bout That Chief....

Thank you JV!

Let me know if the text document was helpful....

Ankyu

Jimmy,
The ‘tricks’ notes are GREAT to have! I’m sorry I didn’t provide something for mine, as there are some that could be better understood, but you really did a great job!

However, a couple of points:

1) If the user does not have an expression pedal, what one needs to do is go in to the Home page where the polarity for the Expression is set, and change that value to OFF. Then save the global init file to their CF card by going to the SYSTEM page, and setting SAVE (upper right corner) to Active, then pressing ENTER. This will allow the Expression pedal to be ‘ignored’, and the volume thing should not be a problem,

2) The EG Reset bug is not storing the Running/Shutdown value in presets, but the Legato value should be getting saved. Just a reminder again here.

3) Don’t forget - you must change the Bank number from 7 to whatever number comes next in your banks in the Presets folder. This is VERY important, other wise, the Solaris will not ‘see’ the presets correctly. (If you already have Bank 0-6, then Bank7 is the right name!).

Thanks again, Jimmy, for making such great sounds!

John B.

I cannot wait to try these! I must say I've been looking forward to these since hearing your demos, which are excellent by the way...

THANK YOU!!

Ankyu.......................................Please........................Stay Seated.

And John most guys can figure out how the synth is doing certain tricks, but yes it's helpful if the controllers, which in my case are always changing.
Just depends what hand is free ATM....