by John Bowen » Mon Aug 29, 2016 12:28 pm
pfrancq wrote:I found a little bug in the current OS installed on my Solaris (1.2.1): When storing a patch, it is impossible to choose a bank number above 1O.
This is because there is no Bank folder greater than 10 on your CF card. This you will have to create by loading your CF card in your computer (meaning you must have a CF card reader, of course!). Then you can look at the folder called Presets. Inside there, you should see folders named Bank0, Bank1, Bank2, etc.. And inside of THOSE folders are the actual Preset folders, (named Patch, however!).
To create additional ‘legal’ Banks, they must be numbered in numerical order. In the v4.0 Factory Presets, there are 10 banks, Bank0 through Bank9, therefore, the next Bank created must be named Bank10, and so on. Each Bank folder must have a Patch folder inside.
Probably in the future, I should just create the empty folders for Bank10-Bank127, and make it a part of the factory set.
Thanks for bringing this up!
John B.
p.s. I just tested this out, and it works, but in viewing the CF card back in the computer, I see that the new preset I created was put into the Bank folder, and not the Patch folder. This affects mostly the FX setup, but it’s best to go back in once you’ve created your edits, and drag all of them into the Patch folder. (And something I will add to the bug list!)
[quote="pfrancq"]I found a little bug in the current OS installed on my Solaris (1.2.1): When storing a patch, it is impossible to choose a bank number above 1O.[/quote]
This is because there is no Bank folder greater than 10 on your CF card. This you will have to create by loading your CF card in your computer (meaning you must have a CF card reader, of course!). Then you can look at the folder called Presets. Inside there, you should see folders named Bank0, Bank1, Bank2, etc.. And inside of THOSE folders are the actual Preset folders, (named Patch, however!).
To create additional ‘legal’ Banks, they must be numbered in numerical order. In the v4.0 Factory Presets, there are 10 banks, Bank0 through Bank9, therefore, the next Bank created must be named Bank10, and so on. Each Bank folder must have a Patch folder inside.
Probably in the future, I should just create the empty folders for Bank10-Bank127, and make it a part of the factory set.
Thanks for bringing this up!
John B.
p.s. I just tested this out, and it works, but in viewing the CF card back in the computer, I see that the new preset I created was put into the Bank folder, and not the Patch folder. This affects mostly the FX setup, but it’s best to go back in once you’ve created your edits, and drag all of them into the Patch folder. (And something I will add to the bug list!)