I'm unfortunately experiencing occasional (like in, some times it works) BSOD's on Windows 10/Scope 7 (64 bit) (Both XITE and PCI) when I load either Solaris v4.1 (Don't have v5.0) or Qwave (Qwave is the worst of the two though) caused by different sys-files:
Stop Code: SYSTEM_SERVICE_EXCEPTION
JBMidiEv64.sys
PAGE_FAULT_IN_NONPAGE_AREA
What failed: ScopeXite.sys
What failed: ScopePCI.sys
Both synths worked fine on my Windows 7 (64 bit) Scope 7 installation on this very same computer!?
The MoBo I'm using is the one recommended by SonicCore: ASUS H81-PLUS.
I have tried to reinstall both synths with the newest files found from SonicCores website - did not do the trick.
I have trawled PlanetZ for a solution, found a few cases that seemed similar from when Scope 7 was first released, but the solutions found in these cases did not do the trick in in my case either.
Does anybody have any good ideas?
Also, I'd appreciate it, if others would please double check this and try to load Qwave a few times on a Windows 10/Scope7/64bit installation and see what happens.
I have a thread running on this same issue on PlanetZ here:
https://forums.scopeusers.com/viewtopic ... c3#p342099
I'm unfortunately experiencing occasional (like in, some times it works) BSOD's on Windows 10/Scope 7 (64 bit) (Both XITE and PCI) when I load either Solaris v4.1 (Don't have v5.0) or Qwave (Qwave is the worst of the two though) caused by different sys-files:
Stop Code: SYSTEM_SERVICE_EXCEPTION
JBMidiEv64.sys
PAGE_FAULT_IN_NONPAGE_AREA
What failed: ScopeXite.sys
What failed: ScopePCI.sys
Both synths worked fine on my Windows 7 (64 bit) Scope 7 installation on this very same computer!?
The MoBo I'm using is the one recommended by SonicCore: ASUS H81-PLUS.
I have tried to reinstall both synths with the newest files found from SonicCores website - did not do the trick.
I have trawled PlanetZ for a solution, found a few cases that seemed similar from when Scope 7 was first released, but the solutions found in these cases did not do the trick in in my case either.
Does anybody have any good ideas?
Also, I'd appreciate it, if others would please double check this and try to load Qwave a few times on a Windows 10/Scope7/64bit installation and see what happens.
I have a thread running on this same issue on PlanetZ here:
https://forums.scopeusers.com/viewtopic.php?f=1&p=342099&sid=74af45355adadcd3863e5411e38c3dc3#p342099