OS 2.2: Mod Matrix Reporting does not display certain filter modulation paths
Moderator: Solaris Moderators
OS 2.2: Mod Matrix Reporting does not display certain filter modulation paths
Depending on the filter type, there may be two or three modulation destinations. Most filters have only “cutoff” and “resonance” as destinations, but e.g. the comb filter and the vocal filter have a third destination (“damping” / “x-fade”). It seems that modulation paths to these third filter destinations are not displayed in the Mod Matrix Reporting. Also, if you choose a filter type with only two destinations and turn the encoder further past the “resonance” entry, the corresponding modulation path seems not to be displayed.
Re: OS 2.2: Mod Matrix Reporting does not display certain filter modulation paths
Yes, confirmed. Thanks for reporting! It'll get fixed.
Also I just wanted to mention something since it wasn't in the notes: if the Amount parameter is set to zero then the modulation won't appear in the ModMtx page even when source and destination are set because it doesn't really have any effect. That's as intended.
Jim
Also I just wanted to mention something since it wasn't in the notes: if the Amount parameter is set to zero then the modulation won't appear in the ModMtx page even when source and destination are set because it doesn't really have any effect. That's as intended.
Jim
Solaris #249
Who is online
Users browsing this forum: No registered users and 0 guests